Spray splitting Reasons: (1) The paint viscosity is too low; (2) The spray pressure is too high; (3) The inner diameter of the fan control hole is too large; (4) The paint is insufficient; (5) The atomizing air passage is blocked. Solution: (1) Increase paint viscosity (2) Reduce spraying pressure (... read more
Left or right reasons:(1)The fan control hole on the side of the air cap is blocked;(2)Damaged air cap Solution: 1.Clean atomizing cap 2.Replace the atomizing cap Causes of excessively thick spray center:(1)Viscosity of sprayed coating is too high;(2)The spray pressure is too low;(3)The nozzle diame... read more
1. Erosion. When the liquid with a high flow rate passes through the metal surface at the nozzle hole, it will erode the nozzle hole, causing the nozzle pressure to decrease and the spray state to become irregular. The probability of nozzle erosion depends on the hardness of the liquid and the amoun... read more
1. average coating distribution 2.The coating must not be too thick or too thin The distance between the nozzle outlet and the object to be coated is called the gun distance. The smaller the gun distance, the greater the spray pressure, and the greater the impact of the air pressure on the product, ... read more
The paint spray gun is held by the palm, thumb, little finger and ring finger. The middle finger and index finger pull the trigger. Some painters change the way of holding the gun from time to time, sometimes using only the thumb and palm with the little finger, and sometimes with the ring finger to... read more
We are a professional production of air spray guns manufacturers in China.
Products
Mobile
Copyright © Taizhou Chaotian Pneumatic Tools Co, Ltd. All Rights Reserved. Design By: HWAQ China Spray Guns Suppliers Air Spray Guns Manufacturers
